Sanitizer Installation - Delta UV E Serie Installationshandbuch

C. SANITIZER INSTALLATION
The DELTA UV unit comes with all internal components fully assembled and ready for installation.
Only the Inlet/Outlet unions and pressure gauge need to be installed to ready your unit for installation.
Your DELTA UV unit will need to be plumbed into your pond or swimming pool circulation
We recommend the presence of a by-pass.
The inlet for the water is at the bottom of the DELTA UV unit.
The SOLID COLOR union tail piece is used on the BOTTOM union.
The outlet for the water is at the top.
The CLEAR union tail piece is used on the TOP union.
1) Install the union tail pieces by screwing them into the union nuts on the DELTA UV unit.
2) DO NOT OVERTIGHTEN (hand tightening is sufficient). Overtightening will break the union nuts.
Connect the DELTA UV unit to the filtration unit as shown below:
Filtration unit
Timer
The DELTA UV unit must never be connected to the same terminal strip as the filtration pump(s) and/or boosters
in your system.
Edition 31/10/2013 - version I
Inlet / Outlet UNIONS
OUTLET VALVE
Heating
(swimming
pool)
FILTER
PUMP
INLET
VALVE
ELECTRICAL BONDING
Live
Contactor
= Brown
Neutral
= Blue
Earth =
Green/Yellow
Delta_E_et_ES_(Multi)
BY-PASS
VALVE
THE EQUIPMENT MUST BE IMPERATIVELY
SLAVED TO THE FILTRATION.
system.
• Connect the DELTA UV unit to
the contactor coil.
• Check that the fuse or circuit
breaker is suitable for the power
drawn by all the equipment
connected.
page 14/55