Using The Product - LEITZ PRO 2 Bedienungsanleitung

• Only use batteries of the type specified.
• Do not dismantle or short circuit the battery and keep the battery
away from fire. Never attempt to charge non-rechargeable
batteries (danger of explosion!).
Safe use of radio transmitters
The product emits low-powered radio (RF) signals when the
rocker buttons are pressed. Radio signals can interfere with other
electronic devices.
• Do not use the product in locations where it is forbidden to use
electronic devices (e.g. in aircraft or hospitals).
• Do not use the product near medical equipment. When in doubt,
ask a doctor.

Using the product

To use the presenter
1. Remove the USB wireless receiver
2. Make sure the USB connector is slid out fully.
3. Plug the USB wireless receiver
computer. The computer installs a driver. No further steps are
required.
4. Open the desired application on your computer
(e.g. PowerPoint®).
5. Use the rocker buttons
(Equivalent to pressing the page-up/page-down keys on the
computer keyboard.)
• To use the laser pointer: Hold the Presenter so that the laser
outlet is facing away from you. Then press the laser button

To prevent early discharge, remove the batteries when the product
is not in use.
Replacing the ball pen
1. Remove the USB wireless receiver
2. Unscrew the upper part of the Presenter.
3. Move the latch
4. Pull out the ball pen and replace with a new one (type D1 or
similar, 67 mm).

to move to the previous/next page.


upwards.
D
.

into a free USB port on your

.

3
.
B