Philips GC9950 Handbuch Seite 12

EnGlish
12
3 Take the anti-calc cartridge out of the water tank and discard it.
4 Open the lid of the anti-calc cartridge storage compartment (1) and
take out the anti-calc cartridge (2).
Note: You can store new anti-calc cartridges in the anti-calc cartridge
compartment.
Note: To maximise the lifetime of the anti-calc cartridge, leave it packed until
you use it.
5 Remove the packaging and place the new anti-calc cartridge in the
water tank.
Note: to purchase more anti-calc cartridges, go to www.philips.
com/support.
automatic Calc Clean
Note: The Auto Calc Clean process is automatically activated the first time you
use the iron after you replaced the anti-calc cartridge.
The appliance cannot be used during the Auto Calc Clean process.
Do not interrupt the Auto Calc Clean process, otherwise the process
restarts.
1 When the Auto Calc Clean process is in progress, the blue AUTO
CALC CLEAN light flashes and the appliance beeps.
This process lasts approximately 3 minutes.
,
During this process it is normal to hear pumping and clicking sounds
,
from the system.
2 After approximately 3 minutes, rinsed water is flushed into the rinse
tray below. The beeping becomes faster and the red light flashes on
the rinse tray.