Charging Instructions; Adjusting The Grind - Cuisinart SG6BE Bedienungsanleitung

• To attach the second grinding container, flip the unit housing over and repeat
assembly instructions (Fig.5).
Your Cuisinart Seasoning Mill is now assembled (Fig.6).
For use with measuring cap:
• To use the measuring cap on either grinding container, grasp the measuring
cap and connect to grinding container by aligning the grooves on the
measuring cap with the ridges in the grinding container.
• Press together until the ridge of the measuring cap rests flat against the
grinding container.
NOTE:When not in use, the measuring cap should remain in the uppermost
grinding container, as the unit housing will not fit into the charging base if the
measuring cap is on the lower container.
To assemble charging base for use:
• Place housing, charging base and all removable parts on a clean, flat surface.
Make sure that all parts have been cleaned and dried thoroughly before
assembling.
• Place the removable grind tray into the charging base so that it fits securely
(Fig7).
NOTE: The grind tray will only fit into the charging base one way.
• Connect power adapter to the charging base by grasping the pin on the power
adapter and inserting it vertically into the back of the charging base until
secure (Fig.8).
NOTE: Do not insert power adapter into the charging base while power
adapter is plugged into a power source.
B. CHARGING INSTRUCTIONS
To charge your Cuisinart Seasoning Mill for use:
• Follow the instructions under the Assembly section.
• Grasp assembled unit securely and make sure it is facing upright. The
Seasoning Mill is facing upright when the Cuisinart logo on the front of the
unit is in proper reading orientation (easy to read and horizontal.) (Fig.9)
• Place the fully assembled Seasoning Mill in the charging base so that the
recessed area on the back of the unit housing fits comfortably with the
protrusion on the charging base (Fig.10).
• Plug charging base into a power socket. The unit is now charging for use
(Fig.11).
NOTE: Unit is properly charging if the red LED illuminates on the charging
base. When the unit is fully charged, the LED indicator will change to blue.
NOTE: Before first use, the batteries must be charged for 12 hours.
C. ADJUSTING THE GRIND
• To adjust the grind from fine to coarse, use the adjustment dial on the
underside of the mill. Turn clockwise for a finer grind and anticlockwise for a
coarser grind, following the arrows on the mill (Fig12).
13