Technical Specifications; Description Of Your Electric Kettle; Before Using Your Kettle; Using Your Electric Kettle - Saba BSF MG15 CI Bedienungsanleitung

Technical Specifications

• Model: BSF MG15 CI
• Nominal voltage 230V 50Hz
• Power rating: 1850-2200W

Description of your electric kettle

Lid
Spout
Body
Water level
indicator
GB

Before using your kettle

Before using the kettle for the first time, it is recommended that you clean it by boiling water once up
to max� level and throwing this water away� Wipe the surface of the appliance with a damp cloth�
NOTE: The maximum capacity of the kettle is 1�7 litres�
66
Lid-release button
Handle
On/Off button�
Base

Using your electric kettle

1� Place the kettle on a flat surface�
2� To fill the kettle with water, remove it from its base, open its lid by pressing the opening
button on its lid, then pour the quantity of water required into the kettle before closing the lid�
The water level must be between the minimum and maximum levels� If there is not enough
water in the kettle, it will turn off before the water has boiled�
NOTE: Never exceed the maximum mark when you fill the kettle, otherwise there is a risk of
splashing of boiling water through the spout� Make sure that the lid is securely closed before
connecting the power cord to an electrical outlet�
3� Place the kettle on its power supply base�
4� Connect the plug of the appliance into an electrical outlet� Push the on/off button downwards�
The light inside the kettle will illuminate and the kettle will begin to boil the water� The kettle
automatically turns off once the water has boiled� If applicable, you will need to wait 30 seconds
before pressing the button again to re-boil the water� You can turn off the appliance by pushing
the button upwards or by removing the kettle directly from its power supply base at any time to
interrupt the boiling�
NOTE: Make sure that no obstacle gets in the way of the on/off switch and that the lid is securely
closed� The kettle will not turn off if its switch is blocked or if its lid is left open�
5� Lift the kettle from its power supply base and then pour the water that it contains�
NOTE: Be careful when you pour the water contained in your kettle, because boiling water can
cause burns� Furthermore, do not open the lid while the water in the kettle is hot�
6� The kettle cannot boil the water again as long as its switch has not returned to the up position�
The kettle can be stored on its power supply base when it is not being used�
NOTE: Always unplug the kettle when it is not in use�
GB
67