Trouble Shooting; Winter Storage - Swim & Fun Filterballs System 100W Bedienungsanleitung

UK
8.

Trouble shooting

Problem
At startup. The pump runs but
pumps no water
The pressure is too low
Leaking filter assembly (between
lid and tank)
The pump is not running
The pump sucks air (bubbles at
the inlet)
Insufficient water supply to the
skimmer or pump
NOTE!
Repairs to the sand filter and pump may only be carried out by qualified, professional
firms, otherwise the warranty will lapse.
9.

Winter storage

When the summer season is over, disconnect all hoses. The water MUST be drained completely
from the filter. Remember also that the water must be drained from the pump through the inlet or
outlet before placing it in a dry, frost-free place. The pump and filter tank are not frost-proof. Frost
damage is not covered under the warranty.
MV-1087-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
Reason
There is air in the system.
The pump is not located at the
same level as the pool bottom.
The pump or hoses may be
blocked with leaves and the like.
Worn or dirty gasket
The plug is not plugged into the
socket
The residual-current device
switches off
Faulty pump motor
Defective hoses
Loose hose clamps
The water level is too low
Trouble shooting
The pump must be lower so the water always
flows naturally towards the pump.
The hoses are primed (see the procedure in
paragraph 6)
Clear the inside of the top valve of dirt and
check for impurities, such as leaves etc the
hoses.
The gasket needs to be replaced with a new
gasket, or cleaned and acid-free Vaseline
applied.
Plug in
Turn the residual-current device on again
Turn it off immediately, either the pump or the
residual-current device is defective.
Replace the entire pump.
Replace the hoses
Tighten the hose clamps
Top up the water in the pool, so the water line
comes up to the pool edge
59