DeWalt XR DCN693 Bersetzt Von Den Originalanweisungen Seite 56

english
Selecting the Mode (Fig. 1)
To select standard sequential mode, slide the mode
selector switch (I) to display the single arrow ( )
icon.
To select RapidCycle sequential mode, slide the
mode selector switch (I) to display the double
arrow ( ) icon.
NOTE: Battery life in RapidCycle sequential mode
will be shorter than in standard sequential mode.
Leaving the tool in standard sequential will give
maximum battery life.
Nail Length Setting (Fig. 1)
DCN693 ONLY
This nailer is equipped with a nail length selection
switch (O) located on the foot.
• For shorter nails, select position 1 by setting the
switch to the left most position.
• For longer nails and more rigorous applications,
select position 2 by setting the switch to the
right most position.
In the event that nails are not driving to depth in
speed setting 1, you may have to switch to speed
setting 2 for additional driving power.
NOTICE: Firing nails under 40 mm in
length using speed setting 2 will cause
excessive wear to your tool and may
result in early failures.
Speed Setting Benefit
2 Power to drive longer nails
Increased tool durability,
1 Increased battery life, Increased
speed of driving nails
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
Proper Hand Position (Fig. 7)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
54
Proper hand position requires one hand on the main
handle (R) as shown.
Preparing the Tool (Fig. 1)
1. Remove the battery pack (L) from the tool and
ensure the tool is locked off.
2. Remove all nails from the magazine (G).
NOTE: If nails don't release press nail support
lever (N).
3. Check if the contact trip (C) can move freely.
4. Reload the nails to the magazine.
5. Insert battery pack.
Using the Trigger Lock-off (Fig. 3)
Each D
e
off (B) which when pushed to the right as shown
in Figure 3, prevents the tool from driving a nail
Typical Nail Length
by locking the trigger and bypassing power to the
50–60 mm
motor.
When the trigger lock-off is pressed to the left,
40 mm
the tool will be fully operational. The trigger lock-
off should always be locked off whenever any
adjustments are made or when tool is not in
immediate use.
Running in the Tool
Please note that this tool requires a run-in period
before it operates with full power due to parts which
need to mesh or wear in together. It may be that
the tool does not drive long nails flush consistently
during this period.
After driving between 500 and 1000 nails the tool
should have run-in and perform at full capacity.
Actuating/Firing the Tool (Fig. 1, 8, 9)
The tool can be actuated by pulling the trigger (A) in
one of two modes: sequential mode or RapidCycle
sequential mode.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
WARNING: Do not use the tool if the
contact trip or nail pusher cannot move
freely.
NOTICE: NEVER spray
or in any other way apply
lubricants or cleaning
solvents inside the tool.
This can seriously affect
the life and performance
of the tool.
WALT nailer is equipped with a trigger lock-