Perlesmith PSXFK1 Montageanleitung Seite 8

2B-3
Drill pilot holes using a 7/32 in.
(5.5 mm) diameter drill bit.
IMPORTANT:
Pilot holes must be drilled to a depth of 3 3/4 in. (95 mm). Be sure to
drill into the center of the stud.
2B-4
Install wall plate [01]
using lag bolts [A] and
washer [B]. Tighten the
lag bolts [A] until they
are pulled firmly against
the wall plate [01.
STEP 3 Install Front Support and End Cap Together
3-1
Install the end caps [04] to Front support [02] with the
preassembled screws.
P7
3 3/4in 95 mm
1
Finished
01
Pre-assembled scews
02
04