Fitting Cpu-Holder - König+Neurath TALO.S Bedienungs- Und Montageanleitung

Fitting CPU-holder

(a) Attach the CPU-holder to the retaining plate (SW 3).
(b) Insert the square shaft into the desk top frame. Screw the
connecting clamp to the square shaft from underneath through
the frame (SW 5).
(c) Screw the retaining plate for the CPU-holder to the connecting
clamp (SW 4). The printer tray can be fitted at the same time if
the retaining plates are offset from each other.
(d) Desk top with desk flap: Before assembly, remove lower part
of the fitting.
(a)
(c)
Safety instructions:
Make sure the attachment has a clearan-
ce of 25 mm in all movable desk positions.
(b)
(d)
49
view from rear