Radio Interference; Laser Radiation - Arcam CDS27 Handbuch

troubleshooting
Problem Possible cause
No power The AC input cord is disconnected.
<
Poor connection at AC wall outlet or the outlet is inactive.
<
No disc playback The disc is loaded upside down.
<
The disc is not playable.
<
< The disc is dirty.
The recorded disc is not correctly finalized.
<
No Disc/Bad Disc < The disc is scratched, dirty, poorly recorded or unplayable.
If a fault occurs, check this troubleshooting table before
No sound The audio cords are disconnected.
taking your unit for repair. <
If the fault persists, attempt to solve it by switching the
Noisy or distorted sound The disc is dirty.
<
unit off and on again.
Poor connections.
<
If this fails to resolve the situation, consult your dealer.
Remote control unit Batteries are not loaded or exhausted.
<
Under no circumstances should you repair the unit
does not operate.
The remote sensor is obstructed.
<
yourself as this will invalidate the guarantee!
Remedy
Connect cord securely.
<
Check the outlet using a lamp or another appliance.
<
Reload the disc with the printed side up.
<
Use a playable disc.
<
< Clean the disc.
Load a disc that is correctly finalized.
<
< Press the POWER switch to switch the power off, press the
POWER switch again and then unload the disc.
Connect the cords correctly.
<
Clean the disc.
<
Check the connections and connect all cords securely.
<
Replace the batteries.
<
Remove the obstacle.
<
E-12
Analogue Audio Output
Digital to Analogue conversion 24-bit 192kHz Delta-Sigma DAC
Signal to noise ratio 110dB CCIR
specifications
Harmonic distortion (1kHz) 0.002%
Frequency response (±0.5dB) 10Hz-20kHz
Output level (0dB) 2.2Vrms
Output impedance 47 Ω
Minimum recommended load 5k Ω
Digital interfaces
Audio outputs 75 Ω co-axial/optical TOSLINK
USB USB 2.0 High Speed (480 Mbit/s)
Ethernet 10/100 10/100
Wireless b/g/n
Physical
Dimensions (W x D x H) 433 x 276 x 75
Weight 5.2kg/7.5kg packed
Power consumption 20W maximum
Supplied accessories
Mains lead, CR902 remote control, 2 x AAA batteries, Wi-Fi antenna
E&OE
NOTE: All specification values are typical unless otherwise stated

Radio interference

The CDS27 player is a digital device which has been
designed to very high standards of electromagnetic
compatibility.
All CD players generate, and can radiate RF (radio
frequency) energy. In some cases this can cause
interference with FM and AM radio reception. If this is
the case, keep the player and its connecting cables as far
from the tuner and its aerials as possible. Connecting
the player and the tuner to different mains sockets can
also help to reduce interference.
EC COUNTRIES – This products have been designed
to comply with EMC Directive 2004/108/EC.
USA – These products comply with FCC Part 15 Class B.

Laser radiation

If the CDS27 player is operated
CLASS II
whilst the outer casing is
LASER PRODUCT
removed, invisible laser
radiation could cause eye
damage.
Continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
E-13