Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6 6
6Safety6Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
6 In this case the flow rate must be reduced at the
isolation valve.
Installation6Instructions
• The fitting must be installed, flushed and tested after
the valid norms!
• If necessary shorten platic hose according to the
table and insert it up to the collar into the shorter blue
marked copper pipe.
Technical6Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Highest possible water pressure at
user's site in Mpa
0,1 – 0,15
0,2 – 0,3
0,4 – 0,7
If the water pressure is greater than 0,5 MPa, fit a pressure reducing valve.
Fault
Insufficient water
Mixer stiff
Mixer dripping constantly with water
heater switched off
4
English
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 5 l/min
Table6for6the6throttle6hose6lengths6to6be6used
8, 10 and 15 liters
without throttle hose
Throttle hose shortened to 90 mm
Cause
– Spray former calcified, dirty
–Cartridge defective, calcified
– Cartridge defective
Assembly6see6page631
Symbol6description
Do not use silicone containing acetic acid!
Cleaning
see enclosed brochure.
Dimensions6(see page 33)
Operation6(see page 34)
When the storage tank is being heated, the
spout will drip.
Test6certificate6(see page 34)
Spare6parts6(see page 35)
When changing the spray former, it is
imperative to use one made for this type of
mixer.
Special6accessories
special tool (58085000) order as an extra
Installation putty order as an extra
Device content
Throttle hose shortened to 90 mm
Throttle hose unchanged
Adjust flow volume at corner valve
Remedy
–Clean spray former, exchanging if
necessary
– Exchange cartridge
– Exchange cartridge
up to 5 liters
Throttle hose unchanged
Werbung
