Whispbar K497W Montageanleitung Seite 35

GB
Fitting Kit
K497W
Fitment
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
Attaches to factory-fitted mounting points
located between rubber seals on door frame
Please check the rear of this manual for
information relating specifically to your
vehicle.
Pull back rubber seal to expose fixed points
on vehicle body.
Carefully remove screw holding on metal trim
Replace screw back through metal trim, hole
in clamp and vehicle body. Tighten screw.
Refit rubber seal.
35