Noise / Vibration Information - Protool GMP 145 Bedienungsanleitung

Storage
Packed tools may be stored in dry unheated storerooms
with temperatures not dropping below – 5 °C. Unpacked
electric tools shall be stored only in dry self-contained
storerooms with temperatures not dropping below + 5 °C,
where sudden temperature changes are prevented.
Recycling
After their service life is ended, submit the tool, its
accessories and packages to a disposal premise to allow
reusing of the raw materials.
To allow material-sorted recycling, all plastic components
are marked with relevant symbols.
Repairs and servicing
Repairs in the warranty and post-warranty periods are
carried out by the servicing workshops listed in the index
of addresses.
Guarantee
We guarantee appliances in accordance with statutory /
country-specific regulations (proof of purchase by invoice
or delivery note). Damage attributable to normal wear and
tear, overload or improper handling will be excluded from
the guarantee. In case of complaint please send the
maschine, undismantled, to your dealer or the Service
Centre for electric power tools.

Noise / vibration information

Measured during cutting mortice in the workpiece
Measurement conditions:
Workpiece: Spruce / 1000 x 140 x 140 mm
Cutting tool: Chain cutter
Operating conditions: Cutting mortices 28 x 40 mm
Noise and vibration levels measured and determined
according to EN 50144-1.
The typical A-weighted noise levels of the electric tool are:
Sound pressure level: 97 dB(A);
Sound power level: 110 dB(A).
Use ear protection!
The typical level of hand-arm vibration is less than 4,1 m/s
GB
Product conformity declaration
We declare with our full responsibility that this guide
frame, assembled with the chain mortiser CMP 150,
complies with the requirements of the following standards:
EN 50144-1, EN 50144-2-14, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3, EN 292 according
to the provisions of the directives 89/336/EEC, 98/37/EC.
Manfred Kirchner
.
2
10