Monitoring The Capacity Of The Jump Start Aid; Charging The Jump Start Aid; Using The Jumpstart Feature - ULTIMATE SPEED UPBS 12000 A1 Bedienungs- Und Sicherheitshinweise

General safety instructions /Set up
recharge able battery and/or
open it. The battery may
overheat, ignite or explode.
Do not expose the recharge-
„ „
able battery to high tempera-
tures. The battery can explode.
Regularly check the battery for
„ „
leakage. Leaking or damaged
batteries may cause burns to
the skin if touched; therefore,
always wear suitable safety
gloves! Carefully wipe up the
liquid with a cloth and avoid
contact with skin and eyes.
If the liquid should come into
contact with your
skin or eyes, immediately
wash out with clean water and
seek medical attention.
• Set up
• Monitoring the capacity
of the jump start aid
To monitor the capacity of the jump start
„ „
aid, press the power button
Step
1. Connect the
8
jumper cable
of the jump start
aid to the car's
startup aid output
6
of the charger
9 .
34 GB/IE/NI
.
4
LEDs
11
LED on the jumper
8
cable glows red
continuously
LEDs 10 , 11 flash red
and green
When charging, the indicator lights
flash. The number of permanently lit indi-
cator lights shows the battery power of
5
the jump start aid. When the device is fully
charged, the indicator lights
permanently lit.
Indicator lights
non permanent
1 permanent
2 permanent
3 permanent
4 permanent

• Charging the jump start aid

Use the power supply adapter cable
„ „
to plug the power bank & jump starter
into a mains socket.
Plug the cable from the power adapter
„ „
into the charging port (5V
on the power bank & jump starter
and then plug into a mains power socket.

• Using the jumpstart feature

When using the jumpstart feature, ensure
„ „
that at least 3 indicator lights
manently lit.
Meaning/Error
The voltage detected
in the charger is not
sufficient to charge
the car battery
Charger ready
5
will be
5
Battery power
0%
25%
50%
75%
100%
12
9
7
/1A)
2
9
are per-
5
Solution
Charge the
charger.
Carry on to step
2