IMER MOVER 190D Handbuch Für Bedienung, Wartung Und Ersatzteile Seite 24

FAULT
The mixer stops during - Too full tank
operation - Lack of pressure in hydraulic circuit
Pumping does not stop at - Air inlet points in tank and delivery manifold obstructed
end of cycle
- Pressure switch not correctly set
The bucket does not lift - Lack of pressure in hydraulic circuit
The buket does not drops - Lack of pressure in hydraulic circuit
IMER INTERNATIONAL S.p.A.
CAUSE
26
REMEDIES
- 200 BAR
- Clean the inlet points on tank and delivery manifold
- Check the pressure switch setting (1.8 bar). This operation must be carried out
- Check the oil level in tank.
- Check setting of pressure relief valve on distributor (40 bar). This operation must