Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita UT2204 Bedienungsanleitung

ENGLISH
1-1. Lock button
1-2. Switch trigger
2-1. Indicator lamp
3-1. Hex nut
3-2. Shaft
3-3. Shaft holder
4-1. Wrench 19
4-2. Notch

SPECIFICATIONS

No load speed (min
Mixing blade diameter
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for mixing wall materials, etc.
(except flammable materials)
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 83 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
For Model UT2204
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2005
Explanation of general view
4-3. Wrench 19
5-1. Mixing blade
6-1. Hex bolt
6-2. Shaft
6-3. Flat surface
7-1. Mixing blade
7-2. Shaft
8-1. Hex bolt
Model
-1
)
Overall length
Net weight
Safety class
2
.
ENE056-1
000087
ENF002-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

ENG003-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to drill safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
2. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
ENH101-5
3. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Do not touch the drill bit or the workpiece
3
8-2. Shaft
8-3. Flat surface
9-1. Filter
9-2. Cover
9-3. Screwdriver
10-1. Limit mark
11-1. Screwdriver
11-2. Brush holder cap
UT2204
550
220 mm
929 mm
3.7 kg
/II
Director
GEB001-2