EasyGO duo comfort Bedienungsanleitung Seite 9

EN
ASSEMBLING THE CANOPY
NOTE! The canopy is packed in the plant in such a way
that one of its halves is bent in the opposite direction.
Before assembling the canopy, bend the half in the other
direction to get 2 bows bent in the same direction.
In order to assemble the canopy, fasten the special plastic
clips on the stroller frame, and then fasten the rear part of
the canopy to the upper part of the frame by means of the
hook-and-loop fasteners (Fig. 10).
Push the plastic tensioners to tight the canopy.
ATTENTION! To prevent damaging it fold the canopy
before folding the pram. If the pram remains folded for
prolonged periods, it is recommended to remove the
canopy entirely in order to avoid damaging its flexible
elements.
ATTENTION! The canopy includes flexible plastic
elements and to prevent their deformation it should not be
exposed to temperatures exceeding 35 °C.
ASSEMBLING AND ADJUSTING THE HEIGHT OF THE
FRONT BAR
In order to assemble the front bar, fasten the plastic clips
to the stroller frame underneath the folding mechanism
(Fig. 11).
The height adjustment is performed by pressing down the
round buttons positioned on both sides of the front bar
NOTE! Remove the barrier before folding the stroller.
FOLDING THE STROLLER
NOTE! Before folding the stroller, remove the railing and
fold the canopy.
In order to fold the stroller, fold the canopy, lift the lower
spacers with your foot (Fig. 12), release the additional
protection on the right side of the stroller, by pressing it
down (Fig. 13), and then push the handles to the front
until complete folding (Fig. 14 and 15).
9