Belkin TuneFM Bedienungsanleitung Seite 8

Storing and Using Presets
1
. To store a preset, select the desired frequency using ▲ or ▼ buttons. Press and hold
the desired preset button (1, 2, 3, or 4) for two seconds. An audible beep sounds in
the transmitted audio when the new frequency is programmed*. The iPod nano
display reflects the change when the memory button is released by showing which
memory button was pressed followed by the frequency saved in that memory
position.
* Do NOT remove the TuneFM from the iPod nano until it returns to the Main Menu
screen or new settings may not be saved.
2
. To transmit over one of your preset frequencies, momentarily press "1", "2", "3", or "4".
This will instantly tune the FM transmitter to the frequency stored in that preset.
Transmission-Volume Setting
Although the default volume setting will be ideal for most conditions,
you may be able to improve the performance of the TuneFM by
adjusting the volume of the transmitted audio signal. The TuneFM
allows you to select one of five volume levels. You may wish to
decrease the volume if you experience distorted audio.
You can access the transmission-volume menu by pressing the "1" and
"2" buttons simultaneously. TuneFM displays the current volume setting on the iPod, which
is represented by "VOL 1" (low), "VOL 2", "VOL 3" (default), "VOL 4", and "VOL 5" (high). You
can then change the volume level by using the up and down arrows. To accept your volume
selection, simply wait for the iPod screen to return to the iPod Main Menu.
Note: The iPod nano has a lower audio-output level than other iPod models, so a volume
setting of "VOL 4" or "VOL 5" works best for iPod nano.
Storing and Using Presets | 08
5356_F8Z125eaBLK_man.indb 8
����������������� ��� ���
������ ��� ���� ���� �
16/1/07 9:37:01 am