User Enrolment Procedure - Inotherm inokey Bedienungsanleitung

EN
OPTIONAL STEP: ASSIGNMENT OF AN ADDITIONAL FUNCTION
(THIS STEP SHOULD BE SKIPPED IF THE FINGERPRINT SHOULD ONLY OPEN THE DOOR)
3
BLUE AND GREEN LEDS WILL FLASH ALTERNATELY.
THE FINGER SHOULD BE PLACED ON THE SENSOR
UNTIL THE GREEN LED FLASHES AND A SHORT BEEP IS
HEARD, WHICH MEANS THE FINGERPRINT HAS BEEN
ENROLLED.
IF A DAMAGED OR AN EXTREMELY NON-
PROMINENT FINGERPRINT WILL TRY TO BE
ENROLLED, THE RED LED WILL FLASH 5 TIMES,
ACCOMPANIED BY 5 BEEPS AND THE OPERATION
WILL BE TERMINATED. A QUALITY, CLEAN AND
SUFFICIENTLY MOIST FINGERPRINT SHOULD BE
CHOSEN FOR ENROLMENT.
32

USER ENROLMENT PROCEDURE

1
TO START ENROLING A USER'S FINGERPRINT, BUTTON
1 ON THE CONTROL UNIT SHOULD BE PRESSED.
The blue LED will start blinking slowly.
2
ADMINISTRATOR FINGERPRINT IS VERIFIED FIRST.
For security reasons an admnistrator fingerprint is needed to start
the user enrolment procedure. When the administrator finger will
be recognized, the green LED will flash, accompanied by a beep.
If a non-administrative finger will be placed on the sensor, the
device will not react and the blue LED will keep flashing.
Follow the steps on the previous page.
BLUE
A
GREEN
1x
BLUE
1x
BLUE
GREEN
U
GREEN
1x