Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Video connection to TV
• The camera can transmit a video signal to an external monitor or to the video
input of a TV. Please refer to the monitor's instruction manual.
• Connect any suitable monitor to the TV-Out plug with the enclosed TV cable.
Inserting Memory Cards
• The unit supports both micro SD and SDHC memory cards as well as TF cards
with a capacity of up to 32 GB.
• Push in the memory card as shown in the diagram on the card slot. Never force
a card into the slot.
• When transporting memory cards, always wait until the card is at the temperature
of its surroundings before using it. Temperature changes and humidity can cause
condensation which can lead to short-circuits.
• To remove an SD / SDHC memory card from the slot, lightly press the raised edge
of the card until it springs out, and then remove it completely.
• SD / SDHC memory cards have a locking system that is designed to prevent un-
intentional erasing of data. Select the "LOCK" position on the side of the card. Ho-
wever, the camera cannot save images to the card if it is set to this position.
Operational Use
Switching the camera on is done by setting the "Off Test On" switch to the "Test"
position. Settings and pro¬gramming are now available.
• Press the switch down to change from Video to Photo mode. Warning! The camera
will automatically switch back into Video mode as soon as you switch back to
"Test". Settings will be displayed on the screen on the upper left!
• Press the "Up" key to switch back from Photo mode to Video mode.
• Press the MENU key to open the Settings menu.
• Confirm with "OK" otherwise your changes will not be stored!
• Press the Up / Down key to select the desired menu point and then activate with
the OK key. If you change settings you must always confirm your changes with
"OK".
• Use the MENU key by repeatedly pressing it to return to the previous menu page.
12
Werbung
