TomTom Car Connect Installationshandbuch Seite 4

bristol_qsg.book Page 5 Monday, September 18, 2006 2:14 PM
• Check voltage
Car Connect works with 12-volt batteries with a negative
grounding, so please check the battery voltage before you
start.
• Check the user manual
To be sure all connections are correct, always refer to the
user manual for details.
Wiring safety
• If needed use cable clamps or tape to secure all
connections.
• Make sure none of the leads are trapped between Car
Connect and the surrounding metalwork or fittings.
• Always wrap tape around wires near metal parts.
• Keep wires away from moving parts or places which get
hot or wet, like heater outlets or doors.
• If in doubt about wire colour coding, check the user
manual, as the same colours can have different functions
in different systems.
• Do not shorten any cables.
• Never tap into the Car Connect power supply lead.
Unauthorized parts
Installation can vary depending on the model of the vehicle.
Additional equipment may be required. Use only the parts
included in the Car Connect box or recommended by
TomTom, as the use of unauthorized parts can cause
malfunctions.
Modifications
Check with the vehicle manufacturer's dealership if you have
to drill holes or modify the vehicle in any way. Always check
behind any place where you need to drill a hole to avoid
damaging other parts.
Fuse changes
If you replace the fuse, use a fuse of the type specified on the
fuse holder.
Before you start
5
EN