Connections - AEG MC 4469 DAB plus Bedienungsanleitung

CAUTION:
• When the batteries are exhausted, the remote control
will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste.
Dispose them in accordance with local regulations.
Handling the Remote Control
WARNING:
Be aware of your fingernails when removing the battery
cover and the batteries.
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight
or near sources of excessive heat.
• Batteries can leak battery acid. If the device is out of use
for a long period of time, remove the batteries.
Remote Control Operation Range
Point the remote control at the appliance no more than 5
metres from the remote control sensor and within 60° hori-
zontally and 20° vertically of the front of the appliance. The
operating distance may vary depending on the brightness
of the room.
22
NOTE:
• Make sure that there is no obstacle between the
remote sensor of the appliance and remote control.
If you install the appliance on a TV stand, etc., the
remote control range may decrease depending on
the thickness or colour of the glass of the TV stand.
• Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as inverter fluores-
cent light.

Connections

AC Power Connection
CAUTION:
• Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage printed on
the rating label on the back or on the underside of the
appliance.
• Before connecting the AC power cable, ensure that
you have completed all other connections.
• Connect the small end of AC socket at the back of
appliance and insert the plug of the AC power cable
into a standard AC wall outlet.
• Be sure to unplug the power cable from the outlet
when the appliance is not in use for an extended
period of time.
• The MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall
remain readily operable.
Analogue Inputs Connection
Connecting DVD player / TV outputs to analogue input of
the appliance.
• Use a RCA audio cable (supplied) to connect the DVD
player / TV audio outputs with the AUX IN (L/R) socket
of the appliance.