Villeroy & Boch CETA Installation - Wartung - Gewährleistung Seite 17

English
1. FITTING
1.1. UNPACKING
1.2. MOUNTING THE BATH IN A BATH HOUSING
(only for Ceta)
The bath must in any case be supported at the place of the feet surfaces at
the backside of the bath. When installing the bath, for example in a frame,
take care to keep a joint of at least 3 mm all around the bath (see figure
2a). This allows the material to expand a little.
Silicon
Sealing plug
To prevent damage during
1
transport, this bath is provided
with protective tape along the
rim, which has to be removed
(see figure 1).
Make sure the bath is undam-
aged before installing it.
A
Detail A (4x)
2a
2b
2c
Setscrew
17