CAMP Matik Handbuch Seite 26

submerge the product in water. After cleaning, lubricate the visible pins of the moving parts with a silicone-based
lubricant spray. Note: cleaning and lubrication are recommended after each use in a marine environment.
REVISION
In addition to the normal inspection required before, during and after each use, this product must be inspected
by a skilled person every 12 months, starting from date the product is first used; this date and the subsequent
checks must be recorded on the product's life sheet: keep this literature for inspection and reference for the life
of the device. Check the legibility of the product's markings.
In case of one of the following defects are present, the product should be withdrawn from service immediately:
Ÿ presence of cracks on any component,
Ÿ presence of permanent deformations on any component,
Ÿ unauthorised modification to the product (welding, drilling, etc.),
Ÿ corrosion that severely affects the surface state of the metal which does not disappear after slight rubbing
with emery paper,
Ÿ Malfunction of the mechanisms of the actuating lever [4], the connecting lever [7], the movable cam [6].
Ÿ Burrs and/or sharp edges on any surfaces that could come in contact with the rope; especially on the
movable cam [6], the fixed cam [5], the front plate [2], and the rear plate [1],
Ÿ significant wear on any part of the device (>1mm),
Ÿ breakage or loss of the mechanism cover [8].
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service
immediately. Each product in the safety system can be damaged during a fall and must be always inspected
before use it again. Do not continue to use a product after a major fall because a damage may have occurred,
even no external signs are visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are
made at least once every 12 months from the date the product is first used and the results are recorded in the life
sheet of the product. The following factors can reduce the lifetime of the product: intense use, damage to
components of the product, contact with chemical substances, high temperatures, tears and abrasions, violent
impacts, failure to maintain as recommended. When suspect that the product is no more safety and reliable,
please contact C.A.M.P. spa or the distributor.
TRANSPORTATION
Protect the product from risks such as those detailed above.
22