Using The Machine - BOMANN cb 1083 Bedienungsanleitung

50424-05-ZP 2750
Assembling and releasing the jug
• Assemble the jug by placing it in position and turning it clockwise until it locks
in place in the recesses.
• Release the jug by turning it through in an anticlockwise direction on the base
and lifting.
Replacing and removing the conical press
• The small press is placed directly on the drive axle until it is flush with the filter.
• The large press is placed on the small press, which acts as an adapter. The
two presses can be separated by pulling.
1. Place the jug in the centre of the housing (position the recess in the jug over
the drive axle) and turn until tight.
2. Now insert the filter into the jug.
3. Depending on the size of the fruit, select the appropriate pressing cone and fix
it firmly to the filter.
Large press cone = large citrus fruit (oranges, grapefruit, etc.)
Small pres cone = small citrus fruit (lemons, limes, etc.)
4. Insert the plug in a duly installed 230V/50Hz socket.
5. Halve the citrus fruit in the middle. Press the fleshy side of one half of the fruit
on to the conical press and keep pressed. The machine starts turning automati-
cally. Results can be improved by releasing the pressure and then pressing
again. This changes the direction of rotation.
CAUTION: Do not use the device for more than 5 minutes!
6. The juice now flows into the container (max. 1l). The flesh of the fruit and the
pips remain in the filter.
7. Now take out the jug to pour the juice. You can also place the jug in the refrige-
rator with the lid closed in order to store the juice.
8. Pull the plug out of the socket after use and clean the device as described
below.
Mains lead take-up
The mains lead can be wound up on the base.
IMPORTANT:
The citrus juices should be consumed as soon as possible. Never store such juices
in metal containers.
• Please remove the mains plug before the device is cleaned.
• Clean the lemon squeezer every time it is used.
27.01.2003 15:41 Uhr

Using the Machine

Cleaning
Seite 31
GB
31