Beper 70.210 Betriebsanleitung Seite 14

Mist Fan Use instructions
USE
FAN ASSEMBLY Fig. 2
1 – Place the fan on a flat and stable surface.
2 – Insert the tubes together and strongly screw with the provided screws. Make sure that the screws
are well screwed to guarantee the perfect stability to the fan, otherwise it will dangerously swing.
3 – Insert the cover base and fix it to the base.
4 – Insert the body of the fan (with control panels) on tubes:
5 – Strongly screw the 2 fixing screws on the motor and tubes .
6 – Screw the nut to regulate the fan height.
7 – Place the rear grid to the body motor nut, in order to put together the holes of the grid with the
motor axis.
8 – Strongly screw the closure nut of the rear grid in order to fix it to the motor.
9 – Place the blades on the motor axis and strongly screw all the parts to block them all.
10 – Insert the hoop nest to fix the 2 grids together (front and rear) ans close all with the furnished
screw.
11 – Place the motor tank on the fan base.
12 – Remove the cover of the tank and fil lit with water.
13 – Check the efficiency of the metallic spring on the tank cover, put the tank cover and close it.
14 – Put the tank on the motor and insert the tube into (requi-
red for the water mist function).
15 – Plug the supply cord to the fan.
USE
Once finished to assembled, check that the plugs (the one which connect the tank to the fan and the
fan itself) are correctly plugged.
Control panels Fig. 3
Plug the supply cord to the socket.
The red light POWER switch on.
Press ON/SPEED to activate the blades (the red light NORMAL illuminate) and choose speed (the
red light DOWN illuminate); pressing many times ON/SPEED you can choose the airflow speed (for
each press the red light illuminate and indicate the selected speed : MEDIUM and HIGH).
Press SWING to activate the fan swing (the red light SWING illuminate). Press again to switch off
swing (the red light SWING switch off).
Press MIST Fig. 4 to activate the water spray (the blue light MIST switch on). Select ON/OFF on
position I (the green light on the mist button illuminate) and choose the intensity of the water spray
(MIN et MAX) with the handle.
!!IMPORTANT!!: the tank must be full before using the mist function.
After use, press MIN, press ON/OFF position 0 and press MIST (the blue light illuminate).
Press TIMER (when the fan is working) to select timer to switch off the fan (once the time sets the
red light switch on). You can choose program max. until 7hours30, each time you press the button
will set + 30 minutes an the red lights illuminate.
Press OFF to stop air-flow, the red light POWER still lights ; it will completely stop when the supply
14