OEZ MP-BC-X B Gebrauchsanweisung Seite 8

Motor drive automatic operation presets
21
Pøedvolby automatického provozu motorového pohonu
Automatic
Switch
operation
position
preset
1 *)
2
Simultaneous
3
winding up and
switching on
In this regime the motor drive cannot be controlled in the remote way by
ON and OFF signals. However, there is full power supply, cannot be
*) Standard factory setting of the switch.
**) When the circuit breaker is switched off by the motor drive electrically with the use
of the OFF push button, the circuit breaker control lever gets into the wound up position
automatically, independently of the automatic operation preset.
***) By pressing the OFF push button, the motor drive only winds the circuit breaker up to the
position .
Circuit breaker
Preset
switching off
description
to position
Automatic
- By overcurrent
winding up
release
is on
- By REVISION
push button
Automatic
winding up
- By auxiliary
is off
release
- By TEST push
button
The motor drive is out of operation, the red LED is lighting.
used while manipulating with it !
Circuit breaker
winding
**) up to position
Motor drive carries
out automatically
The operator must press
the OFF push button
By pressing the ON push button the
motor drive will wind up and switch on
the circuit
- 8 -
Mode 1
Re im 1
Mode 2
Re im 2
Mode 3
Re im 3
Circuit breaker
switching
on to position
By pressing of
ON push button
By pressing of
ON push button
Mode
Auto
ON
Auto
OFF
2 in 1
Warning!
991150d Z00