Internal Parts; Hints - DeDietrich DRS 914 JE Bedienungsanleitung

24

Internal Parts

Storage shelves
The shelves can be removed for cleaning.
To permit storage of food packages of
various sizes, the shelves can be placed
at different heights.
To remove the internal shelf pull forward
until it can be tipped up or down and
removed.
Please do the same in reverse to insert
the shelf at a different height.
The glass shelf above the vegetable
drawers and the bottle shelf should
always remain in position, to ensure
correct air circulation.
Door shelves
To permit storage of food packages of
various sizes, the central door shelf can
be adjusted in height.
Gradually pull the shelf in the direction of
the arrows until it comes free, then repo-
sition as required.
For more thorough cleaning, the top and
bottom door sheves can be easily
removed and refitted in position.

Hints

Saving Energy
Pay careful attention to where the cabinet
is placed. See the section Installation.
When installed correctly the cabinet will
consume less energy.
Try to avoid keeping the doors open for
long periods or opening the doors too fre-
quently as warm air will enter the cabinet
and cause the compressor to switch on
unnecessarily often.
If the ambient temperature is high, the
thermostat knob is on the coldest setting
(higher numbers) and the appliance is fully
loaded, the compressor may run continu-
ously, causing frost or ice to form on the
evaporator. If this happens, turn the knob
to a warmer setting (lower numbers) to
allow automatic defrosting and so a saving
in electricity consumption.
Do not place warm foods inside the appli-
ance. Allow warm foods to cool first.
Keep the heat emitting condenser, the
metall grille on the rear wall of your appli-
ance, always clean.