Daewoo FRN-X22 Serie Benutzerhandbuch Seite 22

3. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on
the control panel for 2~3 minutes to remove any air
(bubble) in the pipes and drain out the initial water.
2) Check for the water leaks again through the water
supply system (tubes, connectors and pipes)
Rearrange the tubes again and do not move the
refrigerator.
18
Information concerning the water
filter
- After use, the water system is subject to low pressure.
Proceed with caution when removing the filter.
- Flush the water system if the appliance has not been in
use for a long period of time, or if the ice/water has an
unpleasant taste or smell. To do this, dispense water
through the water dispenser for several minutes.
If the unpleasant taste or smell remains, replace the
filter.
- Protect from frost: remove the filter cartridge if you
expect the temperature to drop below freezing.
- If pressure surges could occur in the water pipe, do
not install the water filter without a suitable surge
eliminator.
Contact an installation expert if you are not sure
whether pressure surges could occur in the water pipe.
- After installing a new filter:
Discard any ice produced in the first 24 hours after
switching on.
- If no ice has been removed for a long period of time,
empty the ice box and discard any ice produced over
the next 24 hours.