Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TFA_No. 60.5015_Anleitung
17.09.2019
Projection Alarm Clock Radio with USB charging function
• ON and the received radio frequency appears on the display briefly.
• Each keypress with the ▲ or ▼ button will increase/decrease the frequency by 0,1 mHz.
• Hold ▲ or ▼ button for three seconds to start auto-scanning for the next closest radio station.
• Press the VOL button. L00 appears on the display. Press the ▲ or ▼ button to adjust the volume
(L00 - L15).
• If the reception is weak, try to orient the antenna for a better reception.
• Avoid being close to possible sources of interference such as electronic devices and radio equipment.
• Press the SNOOZE/DIMMER button to switch off the radio.
• In the radio mode, no settings (time, alarm, projection and light) can be made.
8.1 Radio station program setting
• You can memorize your 15 favorite stations and recall by just pushing a button.
• Push the RADIO/SLEEP button to switch on the radio.
• Press ▲ or ▼ button to adjust the desired station.
• Press and hold the SET button. MEM appears and 01 is flashing. Press the SET button to save the sta-
tion.
• Press ▲ or ▼ button to adjust the next station.
• Press and hold the SET button. MEM appears and 01 is flashing. Press the ▲ button and 02 is flashing.
Press the SET button to save the station.
• Save in the same way other radio stations (up to 15).
• Press the SET button to recall all preset stations one after the other.
24
16:06 Uhr
Seite 13
Projection Alarm Clock Radio with USB charging function
8.2 Sleep mode
• Press the RADIO/SLEEP button twice to turn on the radio and enter the sleep mode.
• SL and 05 (default) appear on the display.
• Press the ▲ or ▼ button to set the desired sleep time (5, 10, 15, 20, 30, 45, 60, 75, 90 minutes or OFF).
• The display automatically switches back to the current time display.
• Press the RADIO/SLEEP button twice to check the remaining time.
• After time has expired, the radio will switch off automatically.
9. Projection and light
9.1 Projection
• Set the projection arm to the respective position.
• Press the ▲ button in normal mode. The projection of the actual time appears permanently onto the wall
or the ceiling. Press the ▲ button to adjust the brightness in 2 levels or to switch it off (HIGH/LOW/OFF
(default).
• Press and hold the ▲ button to turn the image by 180°.
9.2 Light
• To activate (AU) or deactivate (OFF) the automatic dimming function, press and hold the SNOOZE/
DIMMER button.
25
Werbung
