Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TFA_No. 60.5015_Anleitung
17.09.2019
Projection Alarm Clock Radio with USB charging function
• Only use the supplied power adapter.
• Connect the lead to the device first, then plug the power adapter into the mains socket.
• Do not pull the plug out of the socket by its cable.
• Route the mains cable so it does not come into contact with sharp-edged or hot objects.
Caution!
Risk of injury:
• Keep this device and the battery out of reach of children.
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can
lead to serious internal burns and death within two hours. If you suspect a battery could have been swal-
lowed or otherwise caught in the body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by leaking.
• Wear chemical-resistant protective gloves and safety glasses when handling leaking batteries.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
5. Elements
5.1 LCD display (Fig. 1)
A 1: Time
20
16:06 Uhr
Seite 11
A 2: PM in 12-hour-format
Projection Alarm Clock Radio with USB charging function
A 3: MEM for program memories
A 5: Alarm symbol 2
5.2 Buttons (Fig. 2)
B 1: ▼ button
B 3: RADIO/SLEEP button
B 5: SET button
B 7: ▲ button
5.3 Housing (Fig. 3)
C 1: Battery compartment (screwed)
C 3: Power adapter jack
C 5: Projection arm
6. Getting started
• The CR2032 button cell (included) is a back-up battery to keep the clock operational in the event of a
blackout or other power failure.
• Open the battery compartment using a screwdriver.
• Remove the battery insulation strip. Make sure the polarities are correct (+pole above).
• Re-attach the battery cover, being careful not to over-tighten the screw.
• Insert the adapter into the power adapter jack and connect the power adapter into a mains socket.
Important! Make sure that your household voltage is no more than 240V! Otherwise your device may be
damaged.
A 4: Alarm symbol 1
A 6: SL for Sleep function
B 2: VOL button
B 4: SNOOZE/DIMMER button
B 6: AL button
C 2: Antenna cable
C 4: USB port
21
Werbung
