Installation Notes - Solid State Logic XL-Desk Installationsanweisungen

Safety and Installation Considerations
General Safety
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Do not expose this apparatus to rain or moisture.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with
the manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including amplifiers) that
produce heat.
• There are no user-adjustments, or user-serviceable items, inside
this apparatus.
• Do not remove the covers of this apparatus; doing so will
invalidate your warranty.
• Adjustments or alterations to this apparatus may affect the
performance such that safety and/or international compliance
standards may no longer be met.
• This apparatus is equipped with a headphone socket – excessive
sound pressure from earphones and headphones can cause
hearing loss.
Caution
• Hazardous voltages may be present inside this apparatus.
• To reduce the risk of electric shock, do not perform any servicing
other than that contained in these Installation Instructions unless
you are qualified to do so. Refer all servicing to qualified service
personnel and ensure that all power cords are disconnected when
servicing this apparatus.
XL-Desk Safety & Install Information:

Installation Notes

• When installing this apparatus, place the apparatus on a secure
level surface.
• Ensure that no strain is placed on the cables connecting to this
apparatus.
• Ensure also that such cables are not placed where they can be
stepped on, pulled or tripped over.
• Do not operate this apparatus whilst it is covered or boxed in any
way.
• Do not operate this unit with the covers removed. Performance
may be adversely affected.
Power Safety
• Mains supply to be earthed
• This apparatus is fitted with a universal power supply, approved
and certified for operation in this apparatus. There are no user-
replaceable fuses.
• Multiple power cords may be supplied with this unit – use only
the power cord appropriate to your local power wiring. Alternative
power cords may be used if rated 4.0A or above and fitted with a
3-pin IEC320 connector.
• An external over-current protection device is required to protect
the wiring to this apparatus. This protection device must be
installed according to current wiring regulations. In certain
countries this function is supplied by use of a fused plug.
• If an extension power cable or adaptor is used, ensure that the
total power rating of the power cable and/or adaptor is not
exceeded.
• An external disconnect device is required for this apparatus'. The
appliance coupler is a suitable disconnect device. The appliance
coupler shall remain readily operable.
• Unplug this apparatus during an electrical storm or when unused
for long periods of time.
• All power cords must be disconnected to isolate this apparatus
completely
This is SSL.
www.solidstatelogic.com
EN