Specifications - Solid State Logic XL-Desk Installationsanweisungen

Introduction
Congratulations on your purchase of this Solid State Logic XL-Desk. Please be assured that it is designed to provide
you with many years of reliable service while delivering the pristine audio quality you expect from any Solid State Logic
product.
This leaflet contains practical information for the safe installation of this apparatus. For operational and
connector information, please refer to the User Guide, available from the Solid State Logic website
at... http://www.solidstatelogic.com
EMC Compliance
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at their own expense.
Warning - This is a class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
Instructions for Disposal of WEEE by Users in the
European Union
The symbol shown here is on the product or on its
packaging, which indicates that this product must not be
disposed of with other waste. Instead, it is the user's responsibility to
dispose of their waste equipment by handing it over to a designated
collection point for recycling of waste electrical and electronic
equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects
human health and the environment. For more information about where
you can drop off your waste equipment for recycling, please contact
your local city office, your household waste disposal service or where
you purchased the product.
Standards Conformance
This apparatus fully conforms
with the current protection requirements of
the European community council directives
on EMC and LVD.
PLEASE READ THE FOLLOWING PAGES FOR SAFETY/INSTALLATION AND
XL-Desk Safety & Install Information:
Limited Warranty
Warranty claims will only be accepted if the purchased product has
been used for its intended purpose. Any purchased product used for an
unintended purpose will not be eligible for warranty protection. For all
warranty inquiries or claims please address your claim to the dealer that
you purchased the product from – or to Solid State Logic if the purchase
was directly from Solid State Logic – within a period of two months from
the date on which you detected its lack of conformity with the terms of
the warranty. Please include your original proof of purchase
when initiating the claim.
• Within the EU: Pursuant to the Solid State Logic Terms and
Conditions under European consumer law the purchaser has full
statutory warranty rights for two years from the date of delivery of the
product. The warranty is valid only in those Member States of the
European Union (EU) who have adopted the applicable EU law into
their national legislation. The applicable national legislation
governing the sale of consumer goods is not affected by this warranty.
• Outside of the EU: Outside of the European Union a 12 month
warranty from date of purchase is applicable.
Out of Warranty Repairs
In the event of a fault arising after the warranty period has expired the
unit should be returned to Solid State Logic either directly or via your
local dealer. You will be charged for the time spent on the repair (at
Solid State Logic's current repair rate) plus the cost of parts and
shipping. Note that no units can be accepted for repair without prior
arrangement (see below).
All Returns
• No unit will be accepted for repair by Solid State Logic unless
accompanied by a valid RMA (Return Material Authorisation) number,
obtainable from Solid State Logic prior to shipping.
• All units should be shipped to Solid State Logic in suitable rigid
packaging – Solid State Logic cannot be held responsible for any
damage caused by shipping units in other packaging. In such cases
Solid State Logic will return the unit in a suitable box, which you will
be charged for.
• Do not include the power cable, manual or any other items – Solid
State Logic can not guarantee to return them to you.

SPECIFICATIONS

This is SSL.
www.solidstatelogic.com
EN