ageLOC GALVANIC SPA Bedienungsanleitung Seite 10

EN
ageLOC Body Shaping Gel
Setting
Use this application three times each week to visibly contour,
firm, and smooth skin on arms, thights, abdomen, and
buttocks.
Preparation: Attach the Body Conductor
to the device (Figure 1).
1: Use on clean skin. Apply an ample
step
amount of ageLOC Body Shaping Gel to
Figure 1
the desired area.
2: Push the selection button until the
step
number 4 is lit on the display (Figure 2). This
application will take 5 minutes per area.
Pro Tip: 5 minutes is the recommended
application time for one area, but you may
Figure 2
not need the full 5 minutes.
3: Thoroughly wet hands with NaPCA
step
Moisture Mist or water. Hold the device with
a moistened hand while touching the chrome
plate on the back and begin to slowly glide the
conductor head over your skin (Figure 3).
The device will beep once, twice, or three
times to indicate that it has automatically
Figure 3
adjusted to your skin. After this, your galvanic
application has begun, and the device will
beep every 10 seconds to indicate the unit is on and working,
and every 5 seconds when your application is almost
complete.
16
Conductor
GS 4
4: When your galvanic
step
application is over, the device will
emit a long beep followed by two
short beeps and automatically turn
off. Repeat steps 1 through 3 for
each targeted area. When all
applications are done, remove any
remaining product from your skin
and the device with a damp towel
(Figure 4).
Apply ageLOC Dermatic Effects ® twice daily to help your
skin stay visibly smooth and contoured. On days when you use
ageLOC Body Shaping Gel, apply ageLOC Dermatic
Effects after your galvanic application.
EN
Figure 4
17