Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; External Connections - OHAUS 7000 Serie Handbuch

Indicators
Vorschau ausblenden Andere Handbücher für 7000 Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
EN-2

2. INSTALLATION

2.1 External Connections

Scale Base with Connector to T71P
Ohaus bases with a circular connector can be attached to the external load cell connector.
To make the connection, plug the base's connector onto the external load cell connector, and then rotate the locking ring
clockwise.
To connect an Ohaus base with a circular connector to the T71XW (which does not have an external connector), the Load
Cell Cable Adapter Kit p/n 80500736 may be used to make the connection. Only use this attachment method if the system will
not be used in a Washdown environment. This cable connects to the terminal block inside the T71XW and has an external
connector on the other end.
RS232 Interface Cable to T71P
Connect the optional RS232 cable to the RS232 connector.
Pin
1
2
3
4
5
6
7
8
9
AC Power
Connect the AC power cord (supplied) to the power receptacle then connect the AC plug to an electrical outlet.
Battery Power to T71P
Install the six C-size (LR14) batteries with polarity as shown in the battery compartment.
Mounting Bracket Attachment
Position the wall bracket over the threaded holes on each side of the indicator and install the knobs. Adjust the indicator to the
desired angle and tighten the knobs.
2.2 Internal Connections
Some connections require the housing to be opened.
WARNING: ELECTRICAL SHOCK HAZARDS EXIST WITHIN THE HOUSING. THE HOUSING SHOULD
ONLY BE OPENED BY AUTHORIZED AND QUALIFIED PERSONNEL. REMOVE ALL POWER
CONNECTIONS TO THE UNIT BEFORE OPENING. IF THE UNIT CONTAINS AN OPTIONAL RELAY
CONTROL BOARD, ADDITIONAL
AC OR DC POWER CONNECTIONS MAY STILL EXIST WITHIN THE HOUSING.
Opening the Housing
T71P
Remove the four Phillips head screws from the rear housing. Remove the front housing being careful not to disturb the
internal connections. Once all connections are made, reattach the front housing.
Connection
N/C
TXD
RXD
N/C
Ground
N/C
CTS
RTS
N/C
RS232 Connector
Level
Charge Remaining
0 to 5 %
5 to 25 %
26 to 50 %
51 to 75 %
76 to 100 %
7000 SERIES INDICATORS

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

T71pT71xw

Inhaltsverzeichnis