Temperature Regulation; Maintenance; Cleaning And Maintenance - Igloo ELBA Bedienungsanleitung

Remarks and indications
• After transporting the device, wait about 2 hours before its actuation.
• The fi rst fi lling of the freezing space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not place hot products in cooling devices.
• It is forbidden to place bottles and cans with drinks in freezing device. Their content may expand when
frozen, rupturing the container. Risk of injuries and damages!
• During the day it is unadvisable to place more products in the chamber of the device than its freezing
capacity can handle.
• In order to ensure proper food storage conditions, it is forbidden to fully complete the shelves.
• In order to prevent freezing of the packages it is essential to dry them before placing them in the device.
• Do not block any ventilation holes, which would hamper the cooled air circulation. It is necessary to ensure
proper airfl ow around the device (aggregate ventilation holes cannot be covered).
• Keep the condenser clean. Dirt hinders the heat exchange, causing an increase in electric energy con-
sumption.
• Do not use electric devices inside grocery product storing chamber
• After closing the doors, do not try to use force to open them. Under pressure created inside the device is
equalled within 1-2 minutes, which enables free opening of the doors.
• Avoid unnecessary opening of the doors and leaving them open for a longer period of time.
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence
may result in damage of the device, which is not covered by warranty!

4.1. Temperature regulation

"Igloo" thermostat (temperature regulator) service is described in chapter 7 (p.16)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device
and maintain it within the determined temperature ranges. The producer enters all settings of temperature regu-
lators required for normal functioning of the device. Before primary actuation the user should control and possibly
set the required temperature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious
consequences, including the damage of the cooling device!

5. MAINTENANCE

5.1. Cleaning and maintenance

All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
It is recommended to make a break in the exploitation of the device once a month in order to clean its
interior, naturally defrost the evaporator and verify the condition of door seals.
12
User manual Elba
en
www.igloo.pl