Erone SEL2641R433C4 Bedienungsanleitung Seite 14

5 - RECEIVER LAYOUT
DL1 DL2 DL3
P1 P2 P3
5 6 7 8 9 10 11 12 13 14
RL1 RL2 RL3
6 - TRANSMITTER CODE MEMORISATION
6A) : Transmitter memorising using P1, P2, P3, P4 buttons.
The memorization develops in 2 phases
1): Memorization of the keys transmitters into the memory with association key-relay;
2): Relay operating mode configuration .
The receiver is predisposed for an pulse operation mode of the relay;
The change of the operation mode effects subsequently, as explained in the chapter 8 of the present manual
Relay RL1
Keep P1 pressed down for 4 sec. - DL1 remains lit - The buzzer sounds the bip type "Beep1"- Before the end of the
beep , press the key A or B or C or D of the transmitter. - DL1 turns off - Press again the key A or B or C or D to
confirm and verify the activation of RL1 and the lighting of DL1.
Press P1 for 4
sec , the led DL1
remains lit; the
buzzer sounds
"Beep1"
Memorisation the transmitter into the relays RL2, RL3, RL4
The procedure is similar to that used for RL1, using the buttons P2, P3 or P4 instead of P1.
NOTE2 : In case of memorisation of many transmitter keys , keep pressed the key of the receiver related to the relay
and press in sequence the keys of the transmitters to memorise.
Pag. 14
DL1(Red Led ):
DL2(Green Led ): Displays the Step mode (of the selected relay );
DL4
Dl3(Red Led ):
DL4(Red Led ):
P4
the selected relay );
P1, P2, P3, P4:
BUZ
memorising and for the relay operating mode setting;
BUZ : Signalling buzzer : sounds 4 different "beep" depending upon
the relay: "Beep1","Beep2","Beep3","Beep4";
RL4
RL1, RL2, RL3 : Normally Open contacts relays ( NO );
Fig. 9
Bip1
Press the key A, B, C or D
of the transmitter
Displays the Pulse mode (of the selected relay );
Displays the Timered mode (of the selected relay );
Displays the operating mode in Reduced range (of
Push buttons needed for the transmitters
DL1 turns off
Press again the key A, B,
C or D of the tx to check
T H E S M A R T L I V I N G
RL1 is activated
and Dl1 turn on
Fig. 10