SCREENLINE SL2380 Anwenderhandbuch Seite 14

Deleting a channel
1. Detach the battery module from its base plate
2. Call up the channel to be deleted on the remote control
display by pressing the +/- buttons
3. Keep the button on the battery module pressed until the
LED starts flashing quickly after lighting up
4. Release the button
5. Simultaneously press the up and down keys on the re-
mote control
6. Wait until the LED starts flashing slowly to indicate that
the channel has been deleted and release the buttons
Deleting all of the channels
1. Detach the battery module from its base plate
2. Keep the button on the battery module pressed until the
LED starts flashing more slowly after flashing quickly
3. Release the button
4. All the previously memorised channels will be deleted
For further instructions on using the remote control, refer to
the specific instruction manual.
RECALIBRATION OF THE BATTERY MODULE - SENSITI-
VE AREA
If the battery module is not working properly you can recali-
brate the sensitive area by carrying out one of the following
procedures:
1. Detach the battery module from the support
2. Plug the power supplier into a power socket
3. Plug the micro-USB connector into the port provided
on the module
4. Pull out the connector
Or else
1. Detach the battery module from its base plate
2. Remove the battery compartment cover
3. Remove one of the batteries
4. Fit the battery and the battery compartment cover back
in place
IMPORTANT: during recalibration do not rest your hand or
any other object on the sensitive area.
14