SCREENLINE SL2380 Anwenderhandbuch Seite 13

3. Plug the micro-USB connector into the port provided
on the module.
When the power supplier is connected, the LED will indicate
the following conditions:
• LED flashing: batteries missing, defective or not of a
compatible type.
Immediately unplug the supplier
• LED pulsating: charging underway
• LED steadily lit: charging completed
After charging, unplug the cable and fit the module back onto
its base plate.
IMPORTANT: this action will start a sensor recalibration
cycle; therefore, be careful not to touch the sensitive are-
as until the LED goes off.
PROGRAMMING THE REMOTE CONTROL (OPTIONAL)
If the battery module is equipped with
a radio receiver for remote control, it is
possible to activate the blind by means
of a remote control.
The radio receiver positioned inside
the battery module can memorise up
to 58 channels.
To program the remote control follow
the instructions provided below.
Memorizing a channel
1. Detach the battery module from its base plate
2. Select the required channel on the remote control
transmitter display by pressing the +/- buttons
3. Press the button on the battery module until the respec-
tive LED lights up
4. Release the button
5. Simultaneously press the up and down keys on the re-
mote control
6. Wait until the LED starts flashing slowly to indicate that
the channel has been memorised and release the but-
tons
Button
13