Braun CareStyle Compact IS 2043 Gebrauchsanweisung Seite 16

The appliance emits a loud
noise associated with vibra-
tions (subtle pumping sound is
normal).
The fi rst time the appliance is
turned on, you notice smoke /
smell.
There is too much steam
coming out of the iron.
Water (dirty) droplets and
impurities come out of the
soleplate.
All LEDs are fl ashing.
16
A new anti-limescale fi lter car-
tridge has just been installed.
The water tank is empty.
The anti-limescale fi lter cartridge
is not in place.
The anti-limescale fi lter cartridge
is damaged or shows cracks.
Some parts have been treated
with sealer/lubricant which
evaporates the fi rst time the iron
heats up.
Mode turbo is on.
After the anti-limescale fi lter car-
tridge replacement, remaining
water may drip out of the sole-
plate.
System error.
Continue to press the steam button
until the loud noise stops and steam
comes out of the soleplate.
Refi ll the water tank and press the
steam button until the loud noise
stops and steam comes out of the
soleplate.
Place the anti-limescale fi lter car-
tridge in the compartment.
Inspect the anti-limescale fi lter car-
tridge thoroughly. If you see any
sign of damage or cracks, replace
the anti-limescale fi lter cartridge
with a new one.
This is normal and will stop when
you have used the iron a few times.
If the smoke/smell is still present
after turning off the appliance, con-
tact an authorised Braun Customer
Service.
Activate the iCare or eco mode by
pressing the mode button.
Take the iron out of the base and
position it horizontally on a thick
towel or cloth. Press the steam
button and the reset button at the
same time until the Temperature
Control LED on the iron starts
fl ashing. Release the 2 buttons and
wipe the soleplate dry with a cloth.
Watch out – the soleplate is hot.
Unplug the system, plug in again. If
the problem is still present turn the
appliance off immediately and con-
tact an authorised Braun Customer
Service.