Programming With The Easy Controller - Gewiss GW 90 836 Handbuch

PROGRAMMING WITH THE EASY CONTROLLER

Initialization with the Easy Controller
1. Power up the device through the bus.
2. Have the system acquire the device with one of the following procedures:
• Automatic acquisition:
- select the "Search/Config." or "Scan Range" command in the "System" menu.
• Manual acquisition:
- select the "Add device" menu in the "System" menu;
- briefly press (< 2 seconds) the programming key. The programming LED will light
up during the acquisition process (figure A).
The device acquired is listed with a number allocated, product code and a list of the
channels in the "Devices" view.
Programming the actuator through the Easy base unit (code GW 90 831) or with Easy
Controller (GW 90 837 / GW 90 838 / GW 90 840).
Each output to be programmed can be selected, at choice:
• by pressing the local command button: the corresponding channel will be highlighted
in the channel list;
• directly from the list of channels.
The functions can be created after the devices have been selected.
Names of the functions on the Easy base unit
button
edges
timer mode
priority command
scene
Refer to the Easy base unit or the Easy Controller documentation for further information
on the programming procedures.
load activation or deactivation
load activation or deactivation
load activation with timer
activation of priority commands
activation of the scenes
21
E
N
G
L
I
S
H