Herunterladen Inhalt Inhalt Diese Seite drucken

Vitek VT-3549 SR Betriebsanweisung Seite 11

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
SNOOZE FEATURE
When the alarm sound is on, press the snooze key enter snooze mode. After 8 min-
utes, alarm sound will be wake up automatically. The snooze cycle will be restarted if
you press the snooze key again.
If you leave the alarm sound on for 2 minutes, it will enter snooze mode automatically
with maximum 3 times.
HOW TO STOP AN ALARM
Press [ALARM] on the unit to stop an alarm.
ALARM FEATURE
• Single Alarm
The alarm sound will be activated and the icon will be flashed once when it is armed
and the alarm time is reach.
Once it finished, it will be disabled automatically.
• Pre-Alarm
The pre-alarm sound will be activated and the icon will be flashed if outdoor tem-
perature under or equal two degree C.
Which is programmable 15, 30, 45, 60 or 90 minutes earlier than the weekday alarm
or single alarm time.
HOW TO CHANGE THE TEMPERATURE ALARM SETTING
1. Press once [TEMP ALARM] button.
2. Then Press and hold [TEMP ALARM] button for 2 seconds.
3. Enter the Hi [
button.
4. Press [TEMP ALARM] once to exit.
PRECAUTIONS
This product is engineered to give you years of satisfactory service if you handle it
carefully. Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials.
They may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust, temperature or humidity,
which may result in malfunction, shorter electronic life span, damaged battery and
distorted parts.
4. Do not tamper with the unit's internal components. Doing so will invalidate the war-
ranty on the unit and may cause unnecessary damage. The unit contains no user-
serviceable parts.
5. Only use fresh batteries as specified in the user's manual.
Do not mix new and old batteries as the old ones may leak.
6. Always read the user's manual thoroughly before operating the unit.
49.indd 11
49.indd 11
] or Lo [
] temperature alert setting value by using [ ] or [ ]
11
ENGLISH
02.06.2006 16:59:37
02.06.2006 16:59:37

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis