Manual Setting - Velleman WC40D Bedienungsanleitung

7. Operation
 Remove the protection pin before first use! Dispose
 Do not attempt to reinsert the pin afterwards as
1. Insert a battery in the battery compartment (see below). All
hands will move forward towards 12:00. Note: when the original
position of the second hand is between 11:55 and 12:00, the
second hand will make a full turn before stopping at 12:00. The
same happens with the minute hand when the original position
is between 11:52 and 12:00.
2. Choose a location for the clock (see 6. Working principle).
3. Wait until the clock receives the synchronization signal from the
master clock. This might take up to 15 minutes. Note that the
received signal is usually stronger at night time.
4. Once synchronized, the hands will start moving towards the
correct time.
5. When the clock does not receive the radio-signal, it will start
running showing the wrong time. However, it will keep
attempting to synchronize.

Manual setting

 It is possible to set the time manually, e.g. for use in places where
no radio-signal is received.
 Press and hold the manual setting button. After ± 3 seconds the
minutes and hour hands start moving. Hold down the manual
setting and release a couple of minutes before desired time
setting. Press the manual setting button repeatedly until the
desired time indication is reached. When no press is detected
within 7 seconds, the clock starts running.
V. 02 – 03/03/2016
WC40D
of it in a safe way.
this will surely damage the clock.
5 ©Velleman nv