Safety Instructions; Set Up - lockncharge iQ 16 Sync Charge Box Bedienungsanleitung

iQ 16 Sync Charge Box™

Safety Instructions.

For your safety – Do not operate the iQ 16 SCB if the plug, power socket, power cable or enclosure is
damaged.
To reduce the risk of fire, electrical shock and/or injury, the following basic precautions should be followed:
• The iQ 16 SCB is not intended for use by persons (including children) with reduced physical, sensory
and mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instructions concerning the use of the device by a person responsible for their safety.
• CAUTION: To reduce the Risk of Electric Shock – use only indoors.
• Keep away from all sources of water or moisture. Never expose the devices to the rain or dangerous gas.
• The iQ 16 SCB may be warm during operation. Keep in a dry and cool place and do not cover. Ensure
sufficient ventilation at all times.
• Do not overload the socket-outlets.
• Before using the iQ 16 SCB, check and make sure all devices are correctly and properly connected.
• Arrange the power cord away from traffic areas where it will not be tripped over.
• The iQ 16 SCB is powered when the main supply is connected and switched on.
• Remove the power cord from the main outlet before cleaning. To unplug always grasp and pull the plug.
Never pull the cord.
• Do not try to repair, disassemble or modify the iQ 16 SCB. There are no user-serviceable parts inside.
• Do not use the iQ 16 SCB other than for its intended use.

Set up.

1. If the iQ 16 SCB is in any packaging, remove this to ensure good ventilation and dispose of responsibly.
2. If the iQ 16 SCB is fitted in the cart drawer, no relocation is necessary.
3. Ensure the iQ 16 SCB power-switch is OFF and the mains power outlet is switched OFF.
4. Insert the power cord into the iQ 16 SCB, and plug the other end into the mains power outlet. Switch the
mains power outlet ON.
www.lockncharge.com