Planar PD4010 Bedienungsanleitung Seite 8

S
1.
Remove the lens cover.
2.
Connect the power cord to the projector.
Connect the other end to a wall outlet.
3.
Press the Power button. The Power LED
on the projector turns on. Turn on the con-
nected devices.
4.
The language selection screen appears
(Initial setup only). Select the desired lan-
guage.
1. Press the cursor
Language is highlighted.
2. Press the cursor
ton to confi rm the language, and
close the OSD.
5.
If more than one input device is connect-
ed, press the source bottom to search.
6.
Press the Power button to turn off the
projector. The Powering Down screen
appears.
Note: Pressing the Power button again
within fi ve (5) seconds cancels powering
down the projector.
7.
When the Power LED stops fl ashing, the
projector goes on standby mode.
8
TARTING AND
button until
or Menu but-
Do not unplug the power cord until the Ready LED stops
fl ashing, indicating the projector has cooled down.
S
HUTTING DOWN THE
P
ROJECTOR