Eldes EWP3 Handbuch Seite 23

• DO NOT use the device where it can cause potential danger and
interfere with other devices – such as medical devices.
• DO NOT use the device in hazardous environment.
• DO NOT expose the device to high humidity, chemical environment
or mechanical impact.
• DO NOT attempt to repair the device yourself – any repairs must be
carried out by fully qualified personnel only.
• EWP3 can be powered by a single Primary 3V Lithium 1500mAh
• The system should be installed indoors, in stationary environment ONLY. Choose a location where unauthorised entry is most likely.
• To prevent false alarms, avoid installing the unit in the following locations:
With the lens facing direct sunshine, for instance in front of windows
Places with high temperature fluctuations, such as near fireplaces, boilers, ovens etc.
Anywhere with high dust or air flow
In an area surrounded by metal or thick walls where the wireless signal may be lost
EWP3 WIRELESS MOTION DETECTOR
CR123A battery. When inserting the battery into the battery slots,
mind the polarity terminals!
• A blown fuse cannot be replaced by the user. The replacement fuse
has to be of the kind indicated by the manufacturer (fuse F1 model –
MINISMDC050F 0.5A).
• The device is not meant for outdoor use, i.e. you should use it inside
a building. Protect the device against cold, heat and keep away from
direct sunlight while in storage or operation.
23