Restoring Default Parameters - Eldes EWP3 Handbuch

7. RESTORING DEFAULT PARAMETERS

1. Remove any battery from EWP3.
2. Press and hold the RESET button.
3. Insert the battery back into EWP3.
TERMS OF USE
The following terms and conditions govern use of the EWP3 device and contains important information on limitations regarding the product's use and func-
tion, as well as information on the limitations of the manufacturer's liability.
Please carefully read these terms and conditions. For more information on your product, please visit eldesalarms.com
TECHNICAL SUPPORT
In order to ensure continuous and proper operation of the EWP3 device and uninterrupted service, it is the responsibility of the User to make sure that: (I) the
product is properly installed, and (II) there is constant electrical supply (low batteries must be replaced in time). If you experience difficulty during the installa-
tion or subsequent use of the system, you may contact "ELDES, UAB" distributor or dealer in your country/region. For more information see eldesalarms.com
SAFETY INSTRUCTIONS
Please read and follow these safety guidelines in order to maintain safety of operators and people around:
22
4. Hold the RESET button for approx. 5 sec. and watch the LED indicator
quickly flash.
5. Release the RESET button.
6. Parameters restored to default.
EWP3 WIRELESS MOTION DETECTOR