Eldes EWP3 Handbuch Seite 20

For the purpose of testing this mode might be ignored when using Configuration software or if the service mode is enabled.
When the power saving mode is enabled, the system can be armed even if any movement is detected in the guarded premises. After the
successful arming process, PIR sensor awakes; in case the PIR sensor detects any movement, then the system will cause an alarm. If it is
important for user to monitor the premises during the arming process, then we strongly recommend NOT to use the power saving mode.
MOVEMENT DETECTION CONDITIONS
SYSTEM STATE
ZONE
ATTRIBUTES
Power saved mode ON or Service mode OFF or Configuration
Software OFF or zone type is Instant or Interior Follower
Power saved mode OFF or Service mode ON or Configuration
Software ON or zone type isn't Instant or Interior Follower
20
DISARMED STAY ARMED
NOT STAY STAY NOT STAY
DISABLED DISABLED ENABLED
ENABLED ENABLED ENABLED
ARMED
STAY NOT STAY STAY
DISABLED ENABLED ENABLED
ENABLED ENABLED ENABLED
EWP3 WIRELESS MOTION DETECTOR