XtremeMac TANGO AIR Bedienungsanleitung Seite 8

3. Go to the wireless network settings list on your PC, Mac or iOS
Device.
4. Select "Tango Air XXXXXX" to join the network. If Tango Air XXXXXX
does not appear scan for available networks.
5. Launch your preferred web browser. Type http://192.168.1.12 into the
browser address bar. The configuration web page for Tango Air will
appear. Then select Wireless Setup on the left-hand side.
6. Select Network Name (SSID), choose the Wi-Fi network to which
you will be connecting your Tango Air, and enter your password or
security code.
7. Tango Air will restart. Wait until the Status Indicator turns solid
green.
Playing Music
1. Open a music application on your iOS device to begin
playing music.
2. Click on the AirPlay icon
playback device choices will appear, including "Tango Air XXXXXX".
3. Select a music file and press play. The music will buffer for a few
seconds before music begins playing through the speaker.
4. The Volume controls on the Tango Air can now be used to adjust
the listening level of your digital music device. Press the Volume (+)
Button to increase sound and the Volume (–) to lower the sound.
Note: The 6 LEDs on the top of the system will change to indicate
the volume level. Higher volume will be accompanied by more
illuminated LEDs. The LEDs will show the volume level for 3 seconds
after the volume is adjusted, then the LEDs will change to reflect the
current source.
AUX-in Audio Playback
1. Connect your digital music device (stereo cable not included) to the
3.5mm Aux-in Jack on the back of the system.
2. Press the Source Button to switch to Aux-in mode. The Aux-in
Indicator will illuminate.
3. Select a music file on your device and press play.
4. The Volume controls on the Tango Air can now be used to adjust
the listening level of your digital music device. Press the Volume (+)
Button to increase sound and the Volume (–) to lower the sound.
Note: The 6 LEDs on the top of the system will change to indicate
the volume level. Higher volume will be accompanied by more
illuminated LEDs. The LEDs will show the volume level for 3 seconds
after the volume is adjusted, then the LEDs will change to reflect the
current source.
USB Digital Audio Playback
1. Connect your iOS device to the USB Port on the back of the unit
using a USB cable (cable not included).
2. Press the Source Button to switch to USB mode. The USB Indicator
will illuminate.
3. Select a music file on your iOS device and press play.
displayed on the iOS screen. A list of
9