Getting Started - XtremeMac TANGO AIR Bedienungsanleitung

GETTING STARTED

Wait for at least 45 seconds while the speaker attempts to join the
Wi-Fi network.
Users will need to quit Skype in Win7 for manual wireless setup.
Press the Reset Button on the back of the system to reset network
settings.
AC Connection
1. For models with detachable plugs select the plug specific for your
region and insert a plug by aligning and then sliding the plug on.
2. Remove by pressing down on the button with the tip of a pen or
tweezers, and slide off.
3. Insert the small end of the AC adapter into the DC IN jack. Connect
the other end to a 100V to 240V wall outlet.
Wi-Fi Network Sharing
1. Connect your iOS device (iPhone, iPad or iPod) to the same Wi-Fi
network to which you will be connecting your Tango Air.
Note: You must be running iOS 5 or later to use this method.
2. Press the Power Button on top of the Tango Air to toggle between
OFF and ON. LEDs on the top of the unit will light in sequence to
indicate Power ON status. After the sequence, an LED will remain lit
to indicate last-used source mode.
3. Connect your iPod, iPhone or iPad to the USB port at the back of the
unit using a USB cord.
Note: The iOS device will begin to charge immediately.
4. Press and release the Setup Button on the back of the Tango Air
quickly.
5. A message will appear on your iOS device, asking you to share Wi-Fi
settings. Click "Allow."
6. Your network settings will be transferred to the speaker
automatically, and it will connect to the network. Once connected,
the Status Indicator will change to green. You may then disconnect
the USB cable.
Note: If the Status Indicator flashes red, the connection failed.
Please try the setup again by using the reset button.
Manual Wireless Setup
1. Press the Power Button on top of the Tango Air to toggle between
OFF and ON. LEDs on the top of the unit will light in sequence to
indicate Power ON status. After the sequence, an
LED will remain lit to indicate last-used source mode.
2. Press and hold the Setup Button on the back of the Tango Air for
about 5 seconds to enter Setup mode. Wait until the Status Indicator
begins to flash green and red alternately.
8